Fixed codebook mode in 5300 rate may write up to SUBFRAME_LEN + 4 and
that is considered normal by the reference decoder. Without that additional
padding it might overwrite first elements of LPC history.

The same buffer with saved data is used later in LPC reconstruction, so
it should have some head space for LPC history.

This fixes Bugzilla #327:
Signed-off-by: Kostya Shishkov <kostya.shishkov@gmail.com>

Signed-off-by: Derek Buitenhuis <derek.buitenhuis@gmail.com>

Some calculations were changed in b6a3849a to use mmsize, which was not correct
for the AVX version, which uses INIT_YMM and therefore has mmsize == 32.

Fixes Bug 341.
Signed-off-by: Justin Ruggles <justin.ruggles@gmail.com>

Signed-off-by: Derek Buitenhuis <derek.buitenhuis@gmail.com>

Signed-off-by: Luca Barbato <lu_zero@gentoo.org>

Signed-off-by: Mans Rullgard <mans@mansr.com>

This allows building dct-test even if aandcttab.o is not pulled in
by any enabled codec.  The DCT with which these tables are used does
not use them directly, so building it without the tables is possible.
Signed-off-by: Mans Rullgard <mans@mansr.com>

Reordering the members in this struct reduces the holes required
to maintain alignment.  With this order, the only remaining, and
unavoidable, hole is 3 bytes following left_nnz.
Signed-off-by: Mans Rullgard <mans@mansr.com>

These functions are not faster than other mmx implementations on
any hardware I have been able to test on, and they are horribly
inaccurate.  There is thus no reason to ever use them.
Signed-off-by: Mans Rullgard <mans@mansr.com>

Signed-off-by: Derek Buitenhuis <derek.buitenhuis@gmail.com>

At the moment it only does BGR24, but I plan to add the rest after.
Signed-off-by: Derek Buitenhuis <derek.buitenhuis@gmail.com>

Signed-off-by: Mans Rullgard <mans@mansr.com>

The standard syntax requires two destination registers for
LDRD/STRD instructions.  Some versions of the GNU assembler
allow using only one with the second implicit, others are
more strict.
Signed-off-by: Mans Rullgard <mans@mansr.com>

64-bit CPUs always have SSE available, thus there is no need to compile
in the 3dnow functions. This results in smaller binaries.

This will allow adding dca.c with tables used from other files.

They are managed in get_packet()
Signed-off-by: Luca Barbato <lu_zero@gentoo.org>

This fixes compilation with YASM disabled.

The yadif mmx optimizations contain the pmaxsw and pmaxub mmxext
instructions, causing sigills on CPUs that do not support mmxext.

This completes the conversion of h264dsp to yasm; note that h264 also
uses some dsputil functions, most notably qpel. Performance-wise, the
yasm-version is ~10 cycles faster (182->172) on x86-64, and ~8 cycles
faster (201->193) on x86-32.