Commit f422f474 authored by Stefano Sabatini's avatar Stefano Sabatini

doc/indevs/libcdio: apply minor spell fixes, extend documentation

parent c8bec255
...@@ -627,20 +627,47 @@ ffmpeg -f lavfi -i "movie=test.ts[out0+subcc]" -map v frame%08d.png -map s -c co ...@@ -627,20 +627,47 @@ ffmpeg -f lavfi -i "movie=test.ts[out0+subcc]" -map v frame%08d.png -map s -c co
@section libcdio @section libcdio
Audio-CD input device based on cdio. Audio-CD input device based on libcdio.
To enable this input device during configuration you need libcdio To enable this input device during configuration you need libcdio
installed on your system. Requires the configure option installed on your system. It requires the configure option
@code{--enable-libcdio}. @code{--enable-libcdio}.
This device allows playing and grabbing from an Audio-CD. This device allows playing and grabbing from an Audio-CD.
For example to copy with @command{ffmpeg} the entire Audio-CD in /dev/sr0, For example to copy with @command{ffmpeg} the entire Audio-CD in @file{/dev/sr0},
you may run the command: you may run the command:
@example @example
ffmpeg -f libcdio -i /dev/sr0 cd.wav ffmpeg -f libcdio -i /dev/sr0 cd.wav
@end example @end example
@subsection Options
@table @option
@item speed
Set drive reading speed. Default value is 0.
The speed is specified CD-ROM speed units. The speed is set through
the libcdio @code{cdio_cddap_speed_set} function. On many CD-ROM
drives, specifying a value too large will result in using the fastest
speed.
@item paranoia_mode
Set paranoia recovery mode flags. It accepts one of the following values:
@table @samp
@item disable
@item verify
@item overlap
@item neverskip
@item full
@end table
Default value is @samp{disable}.
For more information about the available recovery modes, consult the
paranoia project documentation.
@end table
@section libdc1394 @section libdc1394
IIDC1394 input device, based on libdc1394 and libraw1394. IIDC1394 input device, based on libdc1394 and libraw1394.
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment